Office ergonomics
How to set up your office chair so your back lasts the day
Published
Most of the chairs we see in Toronto offices already have the adjustments. They just have not been used since the chair came out of the box. People sit on the front edge, the backrest is locked halfway, and the armrests are up under the elbows. By mid-afternoon the lower back is tired, and the usual fix is a rolled sweater or a cushion from home.
We start with the chair, before the monitor and before the keyboard. If the seat is wrong, everything else gets built around a bad height.
Seat height, then the feet
Raise or lower the seat so your feet rest on the floor, or on a footrest if the desk forces the chair up. The thighs should be roughly supported, not hanging, and not so compressed at the front of the seat that you feel the edge. If your feet dangle, you will slide forward. If the seat is too low, the hips fold and the lower back rounds.
A lot of people set the height by feel and never look at the feet. Have a colleague glance at them, or take a second and look down yourself.
Seat depth
You should be able to sit back against the backrest and still have a little space, about a few fingers, behind the knees. If the seat is too deep, you cannot use the backrest without the edge pressing into the calves, so you perch. If it is too shallow, the thighs lose support. On chairs that have a sliding seat, this is a two-minute change. On chairs that do not, you are stuck with a compromise, and that is useful to know rather than pretending the lumbar knob will fix it.
The lower back
We look for the slight natural arch in the lower back, the same “power” position we talk about when people lift. The lumbar support should sit in the small of the back, not halfway up the ribcage. If the backrest tilts, unlock it long enough to find a position you can actually rest in, then fine-tune. A locked upright backrest that you never lean on is just a hard board behind you.
Rolled towels and lumbar cushions show up when the built-in support is in the wrong place or too weak. They can help for a while. They also slip, and they should not be the long-term plan if the chair can be adjusted properly.
Armrests
Armrests should take a little weight off the shoulders without hiking them up. If you have to shrug to reach them, lower them or move them out of the way. If they block you from getting close to the desk, they will force you to reach for the keyboard, and the shoulders will do the work. Some people are better with the armrests down while they type and up when they talk on a call. That is a reasonable habit.
Then check the desk
Once the chair is set, look at the keyboard height. Elbows should hang near your sides, wrists closer to straight than bent up or down. If the desk is too high and the chair cannot go higher without lifting the feet, you need a footrest, or the desk is the problem, not the chair. This is the kind of thing we sort out in a workstation setup workshop, because it is faster to do it with someone standing beside the desk than to describe it in an email.
None of this requires a new chair. If the one you have has a working height lever, a sliding seat, and a backrest that can be positioned in the lower back, start there. If it does not, and several people in the same office are improvising with cushions, that is a reason to look at the furniture as well as the setup. We can help with that during a workplace ergonomic assessment in Toronto or when we recommend a type of chair, not a shopping list. Contact us if you would like a hand with either.
Give the new setup a couple of days. A position that feels odd in the first hour is sometimes just unfamiliar. A position that still hurts after a week is telling you something is still off. Change one thing at a time so you know what helped.

